Use in vehicles, often there will be oil leakage, it will directly affect the technical performance of the car, resulting in oil, fuel waste, consumption of power, influence, clean and tidy car, causing environmental pollution. Because oil spills, oil inside the machine to reduce, resulting in poor mechanical lubrication, cooling enough cause early mechanical damage, or even leaving accidents.
a common main reason for the vehicle oil spills
1. Product quality, poor materials or workmanship; structural design problems.
2. Improper assembly of high-speed, with the surface of dirty, damaged gaskets, displacement or failure to standardize operating procedures for installation.
3. Unequal power fastening nut, sliding wire broken off as a result of deduction or Songkuang work failure.
4. Sealing materials have limited wear and tear after prolonged use, aging deterioration, deformation failure.
5. Adding too much oil, the oil surface of oil too high or a mistake.
6. Bonding surface deflection components, shell damage, the oil leaking.
7. Vent plug, one-way valve plug, due to the pressure difference inside and outside of shell effects, often lead to weaknesses and oil seals.
Second, oil spill prevention measures in the vehicle
1. Lining the role of attention. Auto parts standing position plays a leak-proof seal between the liner effect. If in the material, production and installation of quality does not meet the technical specifications, would not achieve the role of leak-proof seal, and even accidents. Such as the oil pan or valve covers, the contact area is large and easy to compaction, the resulting oil spills.
2. Tighten the nuts on board all types of regulations required tightening torque. Pressure is not too loose gasket leak tight; too tight around the metal bumps and lead screw or threaded efforts caused oil spills. In addition, the sump oil drain plug loose if not tightened or back off, likely to cause oil loss, and subsequent
3. Timely replacement of oil seal failure. A lot of moving parts of the vehicle due to improper installation set, various heart journal and seal edge, deflection and dumped oil. Some seals will be used for a long time and lose their elasticity due to aging of rubber. Found to leak shall be updated.
4. Avoid one-way valve, vent blocked. Tank shell resulting temperature, gas filled the entire space, emissions do not go out, so that increased pressure inside the containment tank to increase oil consumption and replacement cycles. After the engine block ventilation system, an increase of the resistance movement of the piston, so that fuel consumption increases. As air pressure difference inside and outside of shell effect, often lead to weaknesses and oil seals. Therefore required to carry out regular inspection of vehicles, and clear and clean.
5. Properly resolve the various types of pipe joints sealed. Car union nuts are often removable, easy to slip off button and the loose wire, will cause oil leakage. Replacement Joint nut with conical grinding method to solve their seal, so that a solution to seal compression nut.
6. To avoid rejection of the oil hub. Wheel bearings and grease cavity too much wrong or seal assembly, poor quality and aging failure; wheel brake due to frequent high temperature; axle nut loose and so will cause rejection of the oil hub. So use the
No comments:
Post a Comment